Installation steps of sliding door sliding door sliding door sliding door sliding door

[ Chinese wardrobe net ] Most people now use the sliding door for the wardrobe . The sliding door is more convenient to use and does not take up space. Now the wardrobe style of the sliding door is also very beautiful, so everyone knows that the wardrobe is pushed and pulled. How should the door track be installed? The following small series will give you a specific introduction, friends who want to know will come and see it!

Wardrobe sliding door rail

Wardrobe sliding door rails? Installation steps

1. The size of the track box on the upper part of the sliding door should be 12 cm high and 9 cm wide. Like the curtain box, a rail is mounted in the track box to suspend the sliding door from the rail. When the height of the door is less than 1.95 meters, it feels very depressed. Therefore, when doing sliding doors, the height must be at least 195 + 12 = 207 cm.

2. The gold size of the normal door is about 80 cm × 200 cm. Under this structure, the door is relatively stable and beautiful. Therefore, the ratio of the width and height of the sliding door should be similar to the size of the gold.

3. Use the sliding door (bright hanging track box) from floor to top with caution. Since the swing amplitude is too large when pushing and pulling, the sliding door is easily deformed after a long time, and the door cannot be opened after the deformation, which means that it cannot be repaired and cannot be used.

4. Finally, install the sliding door track: fix the upper rail, use the gravity cone (hanging hammer) to hang 3 points on the upper and middle points of the upper rail and draw a 3.3-point surface with the oil pen on the ground, install the upper rail, then Put a hammer to the ground at the center point of the upper track. Vertical lines should be placed at both ends of the track. The lower track is fixed at these three points to ensure that the upper and lower rails are completely parallel, and the sliding of the sliding door is optimal. The state is gone.

Wardrobe sliding door slides? Installation precautions

Since the sliding door is in contact with the wall or the sides of the cabinet, there is no other object in the contact position to block the closing of the sliding door. For example, the position of the drawer in the cabinet should avoid the intersection of the sliding door and be at least 1cm higher than the bottom plate; the drawer in the folding cabinet should be at least 15cm away from the side wall. Pay special attention to the power switch and socket on the wall. The sliding door should be closed and the position of the switch and socket should be changed. Regardless of the floor on which you make any material, you must ensure that the walls of the door are horizontal and vertical. Otherwise, the door will be skewed after the installation is completed. The adjustable error is no more than 10mm.

The above is the installation method of the sliding door of the wardrobe. Now everyone should understand it. The track of the sliding door must be installed. Otherwise, it will be very troublesome in the future. The sliding door will be very used. Not smooth, so everyone must be careful when installing the sliding door track.